Use in closed loop design. Low Temperature Zone Modules K33 equipped with an adjusted thermostatic actuator. K33 is designed to provide constant supply temperatures to the radiant system. Depending on the geographic location of the installation, periodic adjustments to the temperature may or may not be necessary. Rotating the dial of the thermostatic head to a higher number will provide for hotter temperatures.
The designer of the radiant system must ensured the range of temperatures provided by the control is suitable for the installation. The K33 can handle radiant load demands of up to 18.9K BTU's at a 20°F/11K differential. The mixing valve closes on temperature rise. Multiple K33 modules can be used to separate the distinctive temperature requirements between manifold. No special piping, just 2 connections and your installation is complete.
Full port ball valve
3/4” compression fitting
Large ball valve handles, easy handling, visible
Design insulation with optimized function
made of durable elastic EPP, 100% insulation of the fittings, ventilation
openings to cool the pumps.
Free access to the pump head by simply
pulling off the cover
Check valve in return pipe prevents noise
when electronically controlled pumps are used, low pressure drop, manual opener for faster line drain service, spring-actuated-suited for horizontal, vertical or flow down assembly.
Supply and return line can be changed on
site, the mixing valve can be changed without difficulties.
All water-carrying parts are made of brass
All metal temperature gauges can be pulled
off, integrated in the ball valve with an immersion sleeve
Pump can be replaced or serviced without draining the system
3-way mixing valve completely is made of brass, regulated by the thermostatic head with remote sensor on supply pipe, manual temperature adjustment.
Fully assembled with flat sealing union connections at most joints, including 1" connection nut for the installation on PAW-distribution manifolds.
For stand alone assembly, use the conversion kit with wall bracket from the PAW-assembly accessories.
The insulation of the distribution manifold is integrated in the insulation of the zone module.
Dimension 3/4" Materials Fittings Brass Gasket EPDM/NBR Insulation EPP Technical Data Max. Pressure 116 Psi/8 Bar Max Temperature 230°F/110°C Cv Value1.6 Dimensions Zone Module Inlet 1" Male Zone Module Outlet 3/4" compression fitting Pipe Centre Distance90mm/3-1/2" Length255mm/10" Width Insulation180mm/7-1/16" Height Insulation385mm/15-1/8"
Recommended Application: High/Floating temperature zone control up to 18.9 kBTU/h at dT=20°F
A Division of Solarnetix Inc.